[WIP] U-SYNC get confused when connecting multiple Nomes

[Simon]

Status: this will be solved in U-SYNC 1.3 and the plan is to also allow the sync between multiple Nomes even when U-SYNC is used.
This way you can sync multiple Nomes by doing:

Code: Select all

DAW -> U-SYNC -> USB cable -> Nome A -> audio cable -> Nome B + C + D + etc.

----

When connecting multiple Nomes (I or II) to your computer, the U-SYNC daemon gets confused and tends to lose connection. It works, but it might require restarting/replugging things every time a new device is connected or disconnected.

Expected Behavior: the Daemon should stick to the first device connected and not be affected by any other devices connected/disconnected until this first device is disconnected

Actual Behavior: when connecting a new device, it jumps from one device to another, and sometimes loses the connection to both devices

Nome generation (I or II) and Firmware version: both generations, FW 4.0.

[Simon]

This is now solved and will be released in U-SYNC 1.3 shortly!

Works amazingly well, you can switch which device you want to sync on the go, anytime, everything works and resyncs (as it jumps from one device to the next).

U-SYNC Daemon.png (39.39 KiB) Viewed 101 times